CCS Point of Sale

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
trouble_shooting:customer_display [2019/03/01 07:25]
markphillips2
trouble_shooting:customer_display [2019/03/01 07:27] (current)
markphillips2
Line 15: Line 15:
  
 After you have enabled this. Go to CCS from the desktop, then Office. From there, go to Settings - Peripherals (under hardware in the left blue panel) - LCD Customer Display. ​ After you have enabled this. Go to CCS from the desktop, then Office. From there, go to Settings - Peripherals (under hardware in the left blue panel) - LCD Customer Display. ​
-Enable the customer display by checking the 'Use LCD Display'​ checkbox.+Enable the customer display by checking the 'Use LCD Display'​ checkbox.\\ 
 + 
 +When you open the Point of Sale Terminal, the customer display will now show on the new second attached monitor.
  
 ===== Trouble Shooting - When you have been using it and something goes wrong. ===== ===== Trouble Shooting - When you have been using it and something goes wrong. =====

Navigation
From the Ground Up!
Getting Started
Installation Guide
Pre Installation
Install CCS
Install New Database
Guides
Guides
FAQ
Trouble Shooting
Credit Card Setup
Data Cap Epay
CCS Administration
Office - General Management
CCS Terminal
Terminal
Hand Held Setup
Tablet
Kitchen Display
KDS Software Setup