CCS Point of Sale

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
trouble_shooting:customer_display [2019/03/01 07:25]
markphillips2
trouble_shooting:customer_display [2019/03/01 07:27] (current)
markphillips2
Line 15: Line 15:
  
 After you have enabled this. Go to CCS from the desktop, then Office. From there, go to Settings - Peripherals (under hardware in the left blue panel) - LCD Customer Display. ​ After you have enabled this. Go to CCS from the desktop, then Office. From there, go to Settings - Peripherals (under hardware in the left blue panel) - LCD Customer Display. ​
-Enable the customer display by checking the 'Use LCD Display'​ checkbox.+Enable the customer display by checking the 'Use LCD Display'​ checkbox.\\ 
 + 
 +When you open the Point of Sale Terminal, the customer display will now show on the new second attached monitor.
  
 ===== Trouble Shooting - When you have been using it and something goes wrong. ===== ===== Trouble Shooting - When you have been using it and something goes wrong. =====

Navigation

^From the Ground Up!| |[[Getting Started:]]| |[[Installation Guide:]]| |[[Pre Installation:]]| |[[Install CCS:]]| |[[Install New Database:]]| ^Guides| |[[Guides:]]| |[[FAQ:]]| |[[Trouble Shooting:]]| ^Credit Card Setup| |[[Data Cap Epay:]]| ^CCS Administration| |[[ Office:Office - General Management]]| ^CCS Terminal| |[[Office:Terminal]]| ^Hand Held Setup| |[[Hand Held:|Tablet]]| ^Kitchen Display| |[[KDS Software Setup:]]|